Has anybody here put Aeroskis on Airframes Alaska heavy-duty gear, (either stock length or extended)?
I’m about to go down that road, and have talked to Aeroski about some ideas on how to do it, but no need to reinvent the wheel if it’s been done and figured out already...
Aeroskis on Heavy-Duty Gear
- Andy Young
- 100+ Posts
- Posts: 1548
- Joined: Wed Oct 05, 2011 7:10 am
- Location: Alaska, Antarctica, Colorado, and Others
- Contact:
-
- 100+ Posts
- Posts: 104
- Joined: Fri Oct 29, 2010 6:56 pm
- Location: Michigan
- Contact:
- Andy Young
- 100+ Posts
- Posts: 1548
- Joined: Wed Oct 05, 2011 7:10 am
- Location: Alaska, Antarctica, Colorado, and Others
- Contact:
Great! How did you address the issue of the landing gear axle ID (which is smaller than on the stock gear) being smaller than the Aeroski insert OD?
PM if you prefer, or email me direct at youngan1@yahoo.com
PM if you prefer, or email me direct at youngan1@yahoo.com
Who is online
Users browsing this forum: No registered users and 29 guests