Andy, hope these pics help a little. Am sure Wup can explain it a lot better. I did not see pics of yours until after I had changed. I may have gone lazy and turned my 90s inward..
I used the 45 fittings facing aft. You can almost always get another half round for placement. If not loosen and start over they will stretch a little with use. At worse case run a 1/8 pipe thread die up the fitting just a bit.
Not as stellar clean as yours. Can't eat off this hangar floor but hope good enough.
Cleveland brake fittings + HD gear
- gbarrier
- 100+ Posts
- Posts: 1562
- Joined: Thu Jul 14, 2011 5:41 pm
- Location: 9NR4 North Carolina
- Contact:
Who is online
Users browsing this forum: No registered users and 31 guests