Abi 3224a tw assembly
Posted: Fri Apr 22, 2022 12:42 pm
Hi All,
Finally was able to secure a new tire and tube after a three month waitSo it was time to change the tire and clean,inspect and grease everything on the tailwheel…. When remounting the TW assembly to the ABI 1 3/4 spring i noticed the TW head and the spring have a 1/2 inch hole and the bolt is 7/16….The TW head has a small bushing in it, but the spring doesn’t… I found the installation paperwork and it says not to reuse the scott bushing for their installation. Called ABI and didn't get a good answer(Gabe wasn’t available)…. Anybody have the scoop on what is correct?
Thx
Ap
Finally was able to secure a new tire and tube after a three month waitSo it was time to change the tire and clean,inspect and grease everything on the tailwheel…. When remounting the TW assembly to the ABI 1 3/4 spring i noticed the TW head and the spring have a 1/2 inch hole and the bolt is 7/16….The TW head has a small bushing in it, but the spring doesn’t… I found the installation paperwork and it says not to reuse the scott bushing for their installation. Called ABI and didn't get a good answer(Gabe wasn’t available)…. Anybody have the scoop on what is correct?
Thx
Ap