M5 restoration project
- maules.com
- 100+ Posts
- Posts: 3144
- Joined: Tue Aug 29, 2006 4:01 pm
- Contact:
- freedom
- 100+ Posts
- Posts: 239
- Joined: Fri Jul 17, 2015 6:34 am
- Contact:
- maules.com
- 100+ Posts
- Posts: 3144
- Joined: Tue Aug 29, 2006 4:01 pm
- Contact:
- freedom
- 100+ Posts
- Posts: 239
- Joined: Fri Jul 17, 2015 6:34 am
- Contact:
Mine was already installed so hopefully it should be a plug and play... ahahah I've learned the hard way there is no such a thing in building a plane.
Reason I want to install a fairing is that when I opened the wings, inside they were basically in mint conditions. Except where the ailerons cables leave out, and the flaps mechanism inspection cover. I've reenginered the top one to be water tight flush mounted, and the bottom one with plexiglass so to visually inspect the mechanism.
Reason I want to install a fairing is that when I opened the wings, inside they were basically in mint conditions. Except where the ailerons cables leave out, and the flaps mechanism inspection cover. I've reenginered the top one to be water tight flush mounted, and the bottom one with plexiglass so to visually inspect the mechanism.
- freedom
- 100+ Posts
- Posts: 239
- Joined: Fri Jul 17, 2015 6:34 am
- Contact:
- maules.com
- 100+ Posts
- Posts: 3144
- Joined: Tue Aug 29, 2006 4:01 pm
- Contact:
- freedom
- 100+ Posts
- Posts: 239
- Joined: Fri Jul 17, 2015 6:34 am
- Contact:
-
- 100+ Posts
- Posts: 422
- Joined: Sun Feb 03, 2013 7:10 pm
- Contact:
- freedom
- 100+ Posts
- Posts: 239
- Joined: Fri Jul 17, 2015 6:34 am
- Contact:
- TomD
- 100+ Posts
- Posts: 1361
- Joined: Sat Aug 26, 2006 7:13 pm
- Location: Seattle area ( S43 )
- Contact:
- maules.com
- 100+ Posts
- Posts: 3144
- Joined: Tue Aug 29, 2006 4:01 pm
- Contact:
- freedom
- 100+ Posts
- Posts: 239
- Joined: Fri Jul 17, 2015 6:34 am
- Contact:
- maules.com
- 100+ Posts
- Posts: 3144
- Joined: Tue Aug 29, 2006 4:01 pm
- Contact:
- freedom
- 100+ Posts
- Posts: 239
- Joined: Fri Jul 17, 2015 6:34 am
- Contact:
Ok, say the curved portion of the trailing edge is not perfectly smooth is slightly bended in and out, and I had to put a reinforcing backplate outside riveted to the flap/aileron hinge/reinforcing plate inside the wing. Do I have the worry this will get I contact with the flap/aileron leading edge or they are quite far away..
What is the gap, 1/2 in, 1/4in?
What is the gap, 1/2 in, 1/4in?
- maules.com
- 100+ Posts
- Posts: 3144
- Joined: Tue Aug 29, 2006 4:01 pm
- Contact:
Who is online
Users browsing this forum: No registered users and 10 guests